How to fix a sink leak
Looking for a local plumber in Round Rock, TX
The sound of running water is great. It’s therapeutic and can re-energize you, after a stressful day at work or school. But if it’s the sound of your kitchen sink leaking, it may be anything but soothing. Here are some easy fixes for your leaky sink, to save you time and money on hiring someone to do it for you. In case these tips sound a little difficult for you then give us a call, remember we are your local plumber provider in Round Rock, TX.
1) The first step is an identification
Sometimes, just by looking at it, you’ll know exactly why your sink is leaking. If the hot/cold indicators aren’t matching up with the knobs that’s usually because they’ve been switched around. To fix this all you need to do is remove the screw on top that holds them both in place and switch them back where they belong. If that’s not it, then you’ll need to follow the steps listed below in order to correctly diagnose your sink issue.
2) Leaking Faucet
The first thing to look for is a loose connection under the faucet. This can be easily identified by looking at the supply lines. The line that enters the house may be kinked or squished in its fitting. To fix it loosen up the nut behind or underneath your sink with an adjustable wrench, only enough so water can flow through again. Then take some Teflon tape and wrap it around twice before putting it back on hand tight.
3) Leaking Supply Lines
If tightening did not work then you most likely have a cracked supply line inside your wall. This can be very difficult to find because it will require you to look into the crawl space of your house unless you have access to another part of your kitchen. If that’s not an option for you then try the supplies lines leading to the fixture outside
Steps:
1) Turn off the water source feeding the sink
2) Remove the aerator
3-5) Disassemble / Assemble pipe sections until leaking stops
4) Take extra care while handling hot pipes
6) Turn on the water supply and check for leaks
7) Reattach all parts in reverse order
how to replace a bathroom faucet
A bathroom is a very important part of any home. Before we continue explaining how to replace a bathroom faucet remember that we are your plumbers near you in Round Rock, TX. Now a bathroom faucet is where we get ready for the day and get re-energized at night. Having a well-designed and maintained bathroom can be an enjoyable experience. Extending this kind of pleasure to your guests will make you the proud owner of a beautiful and functional bathroom.
There are many reasons why homeowners need to replace parts or all their faucets in their bathrooms from general wear and tear, damage from water leaks or accidents, or when they want to update the style of their whole bathroom with new modern faucets. In order to do this job yourself, it may take some time but there are many benefits in doing so including saving money on plumbing costs by not calling a plumber to do the job.
This guide will show you how to replace a bathroom faucet.
STEP 1 – REMOVING THE OLD FAUCET & INSTALLING THE NEW FAUCETS
Before you begin it is important to turn off both hot and cold water supply lines under the sink. Once this has been done you should use a pair of pliers to loosen the nut on top of each line where they connect with the shutoff valves until all of the water has drained out into the bowl. This will help prevent any accidental damage that may occur by loosening or removing parts while there is still pressure in them from being able to turn off each one’s water supply at its source easily.
You should have already removed the old faucet before you begin this step of removing the shutoff valves. Removing it will probably be fairly simple, depending on what type of faucet is connected to your sink or countertop. If there is a metal nut that holds it in place then this can be done with pliers by loosening them and sliding the nut up. After doing so use your hands to pull out the faucet. Be careful not to damage anything stay away from using force if something feels stuck or doesn’t move easily.
If you are replacing a two-handled kitchen faucet, the process of removing the one under the sink should be about the same as for an exposed single-handle model except instead of pulling off a nut you will be unscrewing the spout with both hands. The nut is normally located underneath the sink where it can’t be seen.
Once the old faucet has been removed then you should use a cloth to wipe down any debris that may be left behind including dirt or rust that may have built up over time.
Toilet not flushing in Cimarron Neighborhood, in zip code 78681
A resident of the Cimarron neighborhood in Round Rock, TX 78681 reported a toilet has been clogged for days and no one is doing anything about it.
The problem was first brought to the attention of police Monday night when a neighbor stopped an officer as he patrolled the area and showed him their back yard, which at the time had several inches of water from backed-up sewage spilling out into the street. The situation was made worse by bright green algae that had started growing on top of the water because of all the recent rain that’s fallen.
When asked if they called DeKalb County about fixing the issue, they told police they had, but there wasn’t much help coming from them either. According to reports, the family said county workers came out Friday afternoon and said they would have to order parts and that there was no estimate on how long it would be before the problem could be fixed.
In between then and now, several inches of water had accumulated in their back yard from backed-up sewage.
The man told police he was afraid a child might wander into the water and get sick if it wasn’t taken care of soon.
Officers could not find any obvious sources for where the line was clogged or even determine whether it was the public or private property where the spillage was occurring. They contacted their dispatcher as well as county officials, but received no clear answers as to what could be done about the situation other than “it’s being looked at.”
Unwilling to wait for help, an officer took the resident to Lowes and helped them purchase some drain cleaner with enzymes in it, which was poured into the toilet.
The Main Street resident told police they had tried using Drano the previous day, but that didn’t work either. The contents of the backed-up sewer were too thick for that product’s chemicals to dissolve, officers said.
Officers went back several hours later with no progress made on unclogging the line. When asked about it again after arriving home from their shift, officers were told by dispatch that several people had called county officials earlier but there was still no word on when any help might be coming or how extensive repairs might be if they do go forward. They finally call us at The Round Rock Plumber and we fixed the problem in 2 hours.